Roll Mode Softgel Machine Care and Maintenance Guide

The rolling mode soft capsule machine adopts discrete drive, with low noise and more stable operation. The mechanical moving parts adopt an independent single-point adjustable lubrication method, which effectively reduces mechanical wear and greatly prolongs the average time. PLC control, the operation mode has large size touch screen mode and switch button mode to choose from, both of which adopt cantilever structure. The control system has a fault diagnosis function, and a network interface is reserved for remote diagnosis after upgrading.
the
Roll mode soft capsule machine features:
1. Micro rubber lubrication, the amount of lubricating oil is only about 1kg per 8 hours per shift, truly realizing no-cleaning of capsules, shortening drying time, and saving a lot of money for users.
2. High productivity, the annual output of a single machine can reach 1 billion grains (based on #8OV, 24 hours a day x 320 days).
3. The chemical spraying of the drug pump and the mold are synchronized and automated, and the spraying time is convenient to adjust.
4. With the display device for the filling volume of the drug pump, the actual loading value can be seen intuitively when adjusting the filling volume, which saves the tedious weighing and verification process.
5. The rubber drum is cooled by liquid cooling, and the temperature adjustment range is 0°C to 20°C.
the
Maintenance Guide:
1. Heating suction filter for dust removal
2. Replacement of the filter screen: the filter screen of the heater should be replaced every 7-10 days, which should be carried out when the equipment is shut down; the filter screen of the air inlet of the vortex fan should be checked (once a month)
3. Regularly replace the rubberized flannelette (once a week is recommended), if the flannelette is damaged, it needs to be replaced immediately
4. Dust removal for electrical cabinets
5. Clean the rubber roller and the rubber groove in time
6. Replace the rubber supply hose and return hose in time
7. Rubber roller cleaning
8. Lubricate the diaphragm pump regularly (once a month)
9. Regularly lubricate the moving motor with lubricating oil (once a month)
10. Regularly check whether the sensor is working normally and whether it is loose (once a week)
11. Regularly check whether the vibrator is loose (once every 15 days). If there is a lot of noise during normal production, stop the machine immediately for inspection
12. Regularly check whether the motor and the return belt are tight or not (once a month)
13. Regularly add lubricating oil to the gears (once every 15 days)
14. Regularly clean the glue box and the glue return pipe, and place the glue to accumulate and block the pipe. (recommended once a week)
15. Regularly check the fixing screws of the tooling, loosen the placement screws, and damage the belt (once a month)