1. At the bottom of the polished seal, connect one of the straws of the special industrial vacuum cleaner, and the other suction tube of the special industrial vacuum cleaner is connected to the waste device.
2. Connect the power supply of industrial vacuum cleaner and polishing machine, and adjust the speed of polishing machine. With a small number of waste shell capsules to test the machine, adjust the negative pressure into the waste air volume, so that just can remove the shell shredded sac is appropriate. If the negative pressure into the wind is too large, it is possible to suck good capsules, too small can not play a role in waste. To the waste air volume in the industrial vacuum cleaner imported adjustment plate adjustment, to waste the situation can be observed from the front observation plate of the de-waste device.
The suction Tube Air volume is also adjusted in the industrial vacuum cleaner adjustment plate.
3. After doing the above preparatory work, you can do the work.
4. Clean the polishing machine and industrial vacuum cleaner in time after the completion of each shift.
If necessary, industrial vacuum cleaners should also be cleaned midway through the work.
5. Adjusting method:
(1) Polishing machine speed adjustment: By the electronic Governor finishing. For fragile capsules, the speed can be appropriate low, and vice versa can be appropriately adjusted.
For tablet polishing, the rotational speed can be appropriately lowered.
(2) Polishing tube tilt adjustment: The tilt is adjusted by the tail branch plate, the tilt is large polishing effect is good, the tilt is small production efficiency is high.
(3) Industrial Vacuum cleaner Adjustment: Professional industrial Vacuum Cleaner has two sets of dust washer pipe device, each has an air suction adjustment plate adjustment, air volume size according to the use of the adjustment.